How to Calculate a Reorder Point and Safety Stock
A reorder point is the stock level at which you place a new order, so the new stock arrives before you run out. Multiply average daily demand by the supplier's lead time in days, then add safety stock. Selling 20 units a day with a 7 day lead time and 40 units of safety stock gives a reorder point of 20 × 7 + 40 = 180 units.
The reorder point formula
Reorder point = daily demand × lead time + safety stock
The inventory reorder point calculator gives 180 for the example. When stock falls to 180, order more.
Why safety stock?
Demand and delivery times vary. Safety stock is a buffer for busy days and late deliveries. Without it, you run out whenever demand during the lead time is above average.
A simple safety stock formula
Safety stock ≈ 1.65 × standard deviation of daily demand × √lead time
The 1.65 factor aims to avoid stockouts in about 95% of order cycles, assuming demand roughly follows a normal distribution. With a daily standard deviation of 4 units and a 9 day lead time:
1.65 × 4 × √9 = 1.65 × 4 × 3 = 19.8, about 20 units.
The safety stock calculator uses this formula. If lead times also vary a lot, you need more.
How much to order: EOQ
The economic order quantity (EOQ) balances the cost of placing orders against the cost of holding stock:
EOQ = √(2 × annual demand × cost per order ÷ holding cost per unit per year)
With 12,000 units a year, 50 per order and a holding cost of 2 per unit a year: √(2 × 12,000 × 50 ÷ 2) = about 775 units. The economic order quantity calculator works this out. Round to supplier pack sizes and check minimum order quantities.
Check that it works
Track how often you run out:
Stockout rate = order lines short of stock ÷ total order lines × 100
18 short lines out of 1,200 is 1.5%, according to the stockout rate calculator. If it is higher than you accept, raise safety stock. If you rarely run out but hold lots of stock, lower it. The days of inventory on hand calculator shows how many days current stock will last.
Update the numbers
Recalculate reorder points when demand changes with the seasons, when you add a new supplier, or when lead times change.
Questions and answers
What is the reorder point formula?
Average daily demand times lead time in days, plus safety stock.
What does EOQ stand for?
Economic order quantity: the order size that minimizes the combined cost of ordering and holding stock.